How do I load hello.exe to my lite5200?

[duncan at winnd.sparks.nv.us (Duncan Winn)]

I would like to run RTEMS on a Motorola lite5200 board.  This board uses 
the MPC5200 processor.  I was able to build RTEMS using the pm520-ze30 
bsp.  At first, I thought I should be using the gen5200 bsp, but I 
couldn't get it to build.

My question is, is the pm520-ze30 the right bsp?  What part of the bsp 
would I need to modify in order to get hello.exe running on the 
lite5200?  How do I go about downloading hello.exe to the board.  When 
the board boots up, it gives me a dBUG> prompt from the Motorola 
standard monitor program.  I was able to build and download a version of 
u-boot to the board if this will make it easier to load RTEMS.  I was 
also able to build and download ELDK Linux (2.4.25) to the board, but 
this didn't get me any closer to RTEMS.  Any help would be greatly 
appreciated.

Thank you, Duncan