How to properly add a new bsp

[groups at chichak.ca (Andrei Chichak)]

I've run into this a couple of times now - I want to add a BSP that is  
derived from an existing one.


QUESTION: What files should I munge and which commands do I use to let  
RTEMS know that the new BSP exists so that I can install it?


I install all of the tools on windows (using MSYS and MinGW), put the  
distribution into place, make a copy of the BSP with a new name, then...


../rtems-4.9.1/configure --target=m68k-rtems4.9 --enable- 
rtemsbsp=cml5282
make install

The installer goes through the motions but terminates with Nothing to  
be done. If I use an existing bsp it works great.

Thanks,
Andrei
---------------------
Andrei Chichak

Systems Developer
CBF Systems Inc.
4-038 NINT Innovation Centre
11421 Saskatchewan Drive
Edmonton, Alberta
T6G 2M9

Phone: 780-628-2072
Skype: andrei.chichak